-
Do not allow water or other liquids to run into the interior of the heater, as this
could create a fire and/or electrical hazard.
-
This heater is intended for indoor household use and similar applications. Do not
use outdoors.
-
Never leave the heater unattended while in use. Always turn the heater off and
unplug when not in use.
-
Do not use the heater while sleeping or place it near a person who is sleeping.
-
Do not place this heater near flammable materials, surfaces or substances. Keep
combustible materials, such as furniture, pillows, bedding, papers, clothes, and
curtains at least 3 feet (0.9m) from the heater.
-
Use the heater in a well-ventilated area.
-
This heater is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. If provided, use handles when moving the heater. Use gloves or oven
mitts to avoid serious injury.
-
Prior to cleaning or other maintenance, the appliance must be disconnected from
the power supply.
-
Allow the heater to thoroughly cool down before handling or cleaning.
-
Do not use any abrasive cleaners or solvents, as heater damage will occur.
-
To disconnect the heater from the mains power, first turn the controls to the OFF
position and then remove the plug from the socket.
-
Ensure the heater is switched off and the power cord is unplugged from the
electrical outlet before cleaning the heater.
-
Never insert fingers or metal objects into the vents and openings of the heater.
-
Avoid placing the power cord in areas where it can become a tripping hazard. Do
not place the power cord under carpeting or cover it with rugs, runners or similar.
-
To avoid a circuit overload when using this heater, do not operate another
high-wattage heater on the same electrical circuit.
-
Always plug the heater directly into a wall socket. Avoid using extension leads
where possible as they may overheat and cause a risk of fire.
-
Do not use this appliance with an external programmer, timer switch or any other
devise which would switch the device on automatically unless this has already
been pre-built into the appliance by the manufacturer.
-
Do not kink or wrap the power cord and plug around the appliance, as this may
cause the insulation to weaken or split, particularly where it enters the appliance.
-
Ensure the mains cable is fully extended before use and arrange it so that it is not
in contact with any part of the appliance.
-
Do not pull on the mains cable. Never move, carry or hang the appliance by the
mains cable.
-
The heater should not be used in a room, of which the floor area is less than 5m².
English | 2