UFESA Tallin Manual De Instrucciones página 13

ASSEMBLY
CAUTION: Ensure the product is fully assembled before plugging it into an electrical outlet.
To assemble it, refer to figure: positioning first the base1 (D) then the base 2 (E) on the
body, making sure to lock with 4 screws supplied (F).
REMINDING (Fig.2): there are 2 corresponding holes at the base, the 2 pillars at the seat
need to pass through these 2 holes when assembly the base onto the fans.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged,
if the power cord is damaged, it must be replaced by the manufacturer or a competent
qualified electrician or a person with similar qualifications, in order to avoid any risk.
Operation: The fan can be operated by the control panel located on the top of the fan(B)
or by remote controller(A).
1. Plug the fan into the standard domestic socket.
2. Press the ON/OFF button
3. Press the SPEED button
of speed level is lighted at indicator cover(C).
4. Press the MODE button
lighted on the indicator cover(C) as NAT ,SLE.
5. Press the OSC button
llation, press the OSC button again, the maximum angle is 86 degree.
6. Press the TIMER button
to 7.5 hours, the interval is 0.5 hour.
When not in use for long periods, the plug must always be removed from the socket.
MANITENANCE AND CLEANING
Warning: before carrying out regular cleaning operations, disconnect the plug from the
mains socket.
To clean the appliance, use a soft, slightly damp cloth; do not use abrasive or corrosive
products.
Do not immerse any part of the fan in water or any other liquid: if this should happen, un-
der no circumstances should hands be put into the liquid; first disconnect the plug from
the mains socket. Then dry the appliance carefully and check that all the electrical parts
are dry: if in doubt, check with professional qualified technician.
It is essential that the motor ventilation holes are free of dust and fibres.
In case of long periods of non-use store the fan, protecting it from dust and moisture; we
recom- mend using the original packaging.
ARMAZENAMENTO DO CABO
Quando a ventoinha não vai ser utilizada durante um longo período de tempo, o
cabo de alimentação pode ser enrolado na base, a ponta do cabo pode ser fixada
por um clipe na parte traseira.
, the fan will start running at LOW speed
to select the desired level, Low, Medium, High, the indicator
to set the fan as Natural or Sleep mode
to allow the fan oscillate the wind direction, to stop the osci-
to set the desired auto power off time, the timer is from 0,5
, the mode is
13