Publicidad
Idiomas disponibles
Idiomas disponibles
Use Side Impact Protection
see images
1
2
1. The enhanced child restraint is delivered with removable side
impact protection pod. This side impact protection pod MUST be
used on the door side of the vehicle. Installation shown in
2. Press the release button to remove side impact protection pod.
Recline Adjustment
see images
-
3
5
Squeeze the recline adjustment button
restraint to the proper position. The recline angles are shown as
There are 3 recline positions for forward facing mode.
!
Please confirm that the backrest adjustment engaged in place.
!
The enhanced child restraint may not fit in all approved vehicles
when used in one of these positions.
Height Adjustment
for Head Support and Shoulder Harnesses
see images
-
6
10
1. Please adjust the head support to proper height according to
!
When used in toddler mode, the shoulder harness height must be
even with child's shoulders.
!
The maximum distance between the shoulder of baby and shoulder
hole is 4 cm.
-2
6
9
1
, to adjust the enhanced child
3
4
-1
6
!
When used in junior mode, the shoulder belt guides must be even
with child's shoulders.
2. Squeeze the head support adjustment lever, meanwhile pull up or
push down the head support until it snaps into one of the 9
positions.
!
Before adjusting the head support height have your child lean
forward slightly.
.
!
Side wings are able to gradually open while the head support is
2
adjusted to the 4th position.
!
The enhanced child restraint may not fit in all approved vehicles
when used in one of these positions.
Using in the Toddler Mode
(Child height 76cm-105cm/Child weight
9kg-19.5kg/15 months - 4.5 years old)
.
4
see images
5
1. If required attach the ISOFIX guides onto the vehicle ISOFIX bars.
!
Please recline the seat to the most upright position before
assembling enhanced child restraint.
2. Place the top tether behind the vehicle seat.
3. Extend the ISOFIX connectors by depressing on the release button
whilst pulling on the connector.
!
There are multiple positions for ISOFIX.
4. Make sure that both ISOFIX connectors are securely attached to
their ISOFIX anchor points.
ISOFIX connectors should be completely green.
.
6
7
5. Press the ISOFIX release button and push the base back against the
vehicle seat until tight.
6. To extend top tether for use, press button on tether adjuster and pull
to lengthen.
7
8
9
10
-
11
32
13
-1
The colors of the indicators on both
14
15
16
11
12
-2
14
10
Publicidad
