Cleaning; Storage; Metrological Verification; Repairs Under Guarantee And Outside Guarantee - Metrix MX 670 Manual De Instrucciones

6.2

Cleaning

Keep the gap between the jaws in a state of perfect
cleanliness.
Set the instrument to the OFF position. Clean the unit with a
cloth and a little soapy water. Wipe over with a damp cloth.
Never use abrasive products or solvents. Dry carefully before
any further use.
6.3

Storage

If the instrument is not used for a period exceeding 60 days,
remove the battery and store it separately.
6.4

Metrological verification

Regular checks must be carried out as for all measurement or
test devices.
To have your devices checked and calibrated, please contact
our COFRAC approved
MANUMESURE centres.
Information and address details available on request:
Tel.: 02 31 64 51 43 Fax: 02 31 64 51 09
6.5

Repairs under guarantee and outside guarantee

Send your devices to one of the Chauvin-Arnoux Metrix-
approved Manumesure regional technical centres.
Information and address details available on request:
Tel.: 02 31 64 51 43 Fax: 02 31 64 51 09
Or return the instrument to your distributor for any intervention
required during and after the guarantee period.
If you ship the instrument, use preferably the original
packaging and specify the reasons for the return as clearly as
possible in a note included with your instrument.
7

WARRANTY

This instrument is guaranteed against any defect in materials
or workmanship, in accordance with the general terms and
conditions of sale.
During the guarantee period (1 year), the instrument must be
repaired only by the manufacturer, who reserves the right to
repair the instrument or to exchange all or part of it. If the
instrument is returned to the manufacturer, the transport costs
are the customer's responsibility.
The guarantee is not applicable in the following cases:
1. misuse of the instrument or use with incompatible
equipment;
2. modifications of the instrument without explicit
authorisation of the manufacturer's engineering
department;
3. work carried out on the instrument by a person not
approved by the manufacturer;
4. adaptation for a specific application, not included in
the definition of the instrument or the operating
instructions
5. impacts, falls or immersion.
MX670 / MX675
metrology laboratories or
35