Connections - Teac TN-300 Manual Del Usuario

When PHONO EQ is ON
Connect to audio input jacks of
amplifier, etc.
When PHONO EQ is THRU
Connect to PHONO inputs of
amplifier, etc.
Analog audio output jacks (L/R)
A
These output analog audio signals.
The PHONO EQ switch setting changes the type of
output signal.
Use the included audio cable (or commercially-
available ones) to connect other equipment to the
output jacks of this unit.
White (L)
Red (R)
10

Connections

B C
A
L R
Amplifier
White (L)
Red (R)
E
D
Included AC adapter
(GPE053A-120050-Z)
V Precautions when making connections
o Do not plug the unit in until after making all
connections.
o Carefully read the manuals of the devices that you
are connecting and follow their instructions when
making connections.
PHONO EQ (audio output setting) switch
B
ON
Signals that have been amplified by the built-in
equalizer amp are output from the analog audio
output jacks (L/R).
THRU
The MM cartridge signal is output directly through
the analog audio output jacks (L/R).
Use this when connecting to equipment that has
PHONO inputs.
o When shipped new from the factory, this is set to
ON.
CAUTION
When set to ON, if connected to the PHONO inputs
of an amplifier, for example, the output from speak-
ers and headphones will be very loud, which could
damage equipment or harm hearing.