Publicidad
Spraying Tips (2)
• Move the gun in a constant and uniform speed. Fast
movements produce thin layer and slow movements
produce thick layers.
• Apply one layer at a time. If needing a second layer read
the manufacturer drying recommendations before applying
a second layer. Remember, to get a better finish apply two
thin layer is better than applying a thick layer only.
• When spraying small areas turn the adjusting screw to
lessen the volume of the material to be applied. This way
using too much paint is prevented and also you will not
spray in excess.
• To assure a uniform application, when possible, do not
pause while spraying an object.
• Do not tilt the paint gun in an angle higher than 45°
• When spraying large areas use a crossed pattern (A).
Cleansing and Care
• It is very important to clean the spray gun thoroughly
after each use.
WARNING
An inadequate cleansing can result in
malfunctioning and will cancel the Warranty.
• Turn the jar to remove it from the gun. Do not remove
completely. Press the trigger to remove remaining product
from inside the spray gun system (B).
• Pour the remaining material into an adequate container.
• Disconnect the paint gun hose.
• Clean the jar, the gasket seal and the suction pipe
thoroughly with a rag soaked with the solvent that is right
for the product.
• Disassemble the regulator, the sprayer, the nozzle and the needle. Clean them with a brush and solvent.
• Clean the paint gun body with a piece of rag moistened with solvent.
Do not immerse the gun in solvent. The gasket may get damaged.
CAUTION
• When the parts are clean assemble back the spray gun.
• Pour a small amount of solvent into the jar.
• Connect the hose to the spray gun.
• Start the compressor and spray into a container until getting clean solvent out through the nozzle.
Needle Seal
• Use special care adjusting the needle seal. This is very
important to obtain good results.
• Adjust the needle seal using a wrench (C).
• Periodically check the seal to be sure it is not damaged.
To gain access to the seal remove the needle and remove
the seal pressing piece (D).
8
ENGLISH
Maintenance
Mantenimiento
Maintenance
C
A
B
D
Publicidad
