Manuales relacionados para Truper PIPI-450
Resumen de contenidos para Truper PIPI-450
- Página 1 Manual Gravity PSI - Spray Gun Work pressure Applies for: Codes Models 101090 PIPI-450 101091 PIPI-451 101092 PIPI-452 Read this manual thoroughly CAUTION before using the tool.
- Página 2 Keep this manual for future references. Start Up The illustrations in this manual are for reference only. They might be different from the real tool. Maintenance Troubleshooting Warranty policy Technical Data PIPI-450 PIPI-451 PIPI-452 Code 101090 101091 101092 Description Gravity Spray Gun...
- Página 3 Safety Warnings for the Use of Pneumatic Tools Keep your work area clean, tidy and well lit. Use adequate personal protection. CAUTION CAUTION Cluttered and dark areas may cause accidents. Using safety glasses, anti-dust mask, safety non-skid shoes, helmet and earplugs used in adequate conditions Never use the tool in explosive environments considerably reduce the risk of injury.
- Página 4 Safety Warnings for the Use of Spray Guns Substances and Materials While operating the device CAUTION • The unit is designed to apply covering CAUTION • Never point the sprayer towards your materials like paint, varnish, enamel, etc. These should body, passersby or animals.
- Página 5 Parts Brush Wrench Filter Fluid Volume Spring Adjusting Screw Needle Sprayer Spray Width Adjusting Screw Needle Liquid nozzle Seal Retaining Ring Shank Trigger Handle Air adjustment Inlet valve (1/4 NPT male connector) ENGLISH...
- Página 6 Preparation • To get a good job done it is important to prepare the surface to be sprayed. Thin the paint of fluid to get the right viscosity before applying. • Always confirm that the surface to spray is free of dust, dirt and grease. •...
- Página 7 Start Up Volume Selector Start up • Turn the screw (A) to adjust the volume of the fluid to be • Start the compressor. sprayed. Turning counterclockwise the volume diminishes • Press the trigger (E) to open the air flow and starts and turning clockwise the volume increases.
- Página 8 Maintenance Cleansing and Care • It is very important to clean the paint gun thoroughly after each use. WARNING Inadequate cleansing will result in malfunctioning and will cancel the Warranty. • Pour the remaining fluid into an adequate container. • Without removing the jar press the trigger to remove all the fluid inside the system.
- Página 9 Troubleshooting Right Mist Pattern Problem Cause Solution Wrong • Remove the obstructions from the nozzle. • Paint build up in the nozzle. CAUTION Do not use metal objects Mist to clean the funnel orifices. Patterns: Half Moon • Paint build up in the nozzle or asperser. •...
- Página 10 Corregidora 22, Col. Centro, Alc. Cuauhtémoc, CDMX C.P. 06060 or at the establishment where you purchased it. For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257 Buy date: www.truper.com...