Power smart PSSAM24BS Manual De Instrucciones página 8

1 Chute Deflector Control Lever
2 Speed Control Lever
3 Auger Control Trigger
4 Chute Rotation Handle
5 Clean Out Tool
6 Upper Handle
7 Lower Handle
A Dipstick/Oil Fill
B
Fuel Tank and Cap
C
Starter Cord Handle
Drive Control Trigger
Located on the right side of the upper handle, the Drive Control Handle is used to engage and
disengage the drive wheels. Squeeze the Drive Control Handle against the upper handle to engage the
wheels; release to disengage.
Drive Speed Control Lever
The Speed Control is located on the center of the panel and is used to set the drive speed and direction
of travel. The speeds include forward and reverse.
Auger Control Trigger
Located on the left side of the upper handle, the Auger Control Handle is used to engage and
disengage the augers. Squeeze the Auger Control Handle to engage the augers; release to disengage
the augers.
Chute Rotation Handle
To adjust snow discharge direction, rotate the handle clockwise or counter-clockwise.... should
rotate 180 degrees.
Skid Shoe
Position the shoes based on the surface conditions. Adjust upward for hard-packed snow. Adjust
downward when operating on gravel or crushed rock surfaces.
Auger Blade and Impeller
8 Tire
9 Skid Shoe
10 Auger Housing
11 Discharge Chute
12 Discharge Chute Deflector
13 Light
14 Drive Control Trigger
D Throttle Control (if equipped)
E Safety Key (if equipped)
F
Push Button Electric Start
G Primer
8