Publicidad
Idiomas disponibles
Idiomas disponibles
When engaged, the auger blades rotate to cut snow and direct it into the auger/impeller housing to be
discharged out the chute.
Clean-out Tool
The chute Clean-out Tool is conveniently fastened to the rear of the auger housing with a mounting
clip. It is used to clean the chute assembly and chute opening when snow and ice become lodged.
WARNING! Never use your hands to clear a clogged chute assembly. Shut off engine and remain
behind handles until all moving parts have stopped before unclogging.
Wheel
13 inch snow tire
LED Light
Located on the front of the panel, this feature provides extra light for increased visibility.
Heated Handle
Open the switch on the back of panel, handles began to heat up.
One Hand Operation
When you activate the drive control trigger and auger control trigger at the same time, the auger
control trigger will be temporarily locked. Release the auger control trigger(left hand)and the auger
switch trigger will remain engaged. This feature allows you to adjust the auger speed, self-propelling
speed, and discharging direction of the snow while the auger rotates.To stop the auger, release the
drive control trigger and both the auger and the self-propel function will stop.
SNOW THROWER PREPARATION
ADD OIL
The snow thrower is shipped without oil. User must add the proper amount of oil before operating the
snow blower for the first time. The oil capacity of the engine crankcase is 20.29 fl. oz. For general use, we
recommend 5W-30, 4-stroke engine oil.
Select good quality detergent oil bearing the American Petroleum Institute (API) service classifications
SJ, SL, or SM (synthetic oils may be used). Use the ASE viscosity grade of oil from the following chart
that matches the starting temperature anticipated before the next oil changes.
Check Oil Level
1. Remove the dipstick (A, Figure 3) and wipe with a clean cloth.
2. Install and tighten the dipstick (A, Figure 3).
3. Remove the dipstick and check the oil level. Correct oil level is
at the top of the full indicator (B, Figure 3) on the dipstick.
Add Oil
1. If the oil level is low, slowly add oil into the engine oil fill (C,
Figure 3). Do not overfill. After adding oil, wait one minute and
then check the oil level.
2. Reinstall and tighten the dipstick (A, Figure 3).
ADD GASOLINE
ENGINE OIL RECOMMENDATIONS
9
Publicidad
