Position Of The Clutch Lever; Changing The Headlight Bulb - DEFYGRAVITY SHERCO TY125 Manual De Propietario

Position of the clutch lever

A
ATTENTION
The hand should be in a relaxed
position and able to apply pressure
on the lever.

Changing the headlight bulb

A
B
In order to be able to pull on the lever properly during
the clutch release operation, it is essential that the
position of the lever is adapted to the physique of
the rider.
To alter the position:
- Loosen the 2 screws
assembly.
- Sit on the seat.
- Place your feet on the footrests.
- Place your hand on the lever and position it as
desired.
- Secure the position by tightening the two
screws .
A
WARNING
After changing the position, check and adjust the
clutch cable.
ATTENTION
This operation should be performed with the ignition
off.
Removal:
- Remove the central screw
centre.
- Remove the two headlight plate rubbers
- Tilt it forwards.
on the lever-switch
A
A located in the top
.
B
51 51