Changing The Brake Light; Changing The Fuse - DEFYGRAVITY SHERCO TY125 Manual De Propietario

Changing the brake light

B

Changing the fuse

A
ATTENTION
This operation should be performed with the ignition
off.
Removal:
- Remove the 3 screws and washers
rear mudguard.
- Disconnect the wiring terminal
- Remove the brake light.
Type: the brake light is a LED unit and the complete
assembly needs to be renewed.
Refitting:
- To refit, proceed in reverse order to removal.
A
ATTENTION
This operation should be performed with the ignition
off.
The fuse is situated below the fuel tank, and
therefore the following have to be removed:
- The seat (Seat chapter).
Removal:
- Remove the rear mudguard by removing the
front screw
- Remove the box-filter support together with the
air filter box.
B
.
A
from the
A
.
53 53