Speed Adjusting Dial - Makita RF1100 Manual De Instrucciones

To start the tool, move the switch lever to the I (ON)
position. To stop the tool, move the switch lever to the O
(OFF) position.
For model RD1101
► 1. Motor unit cord 2. Outlet 3. Lock button 4. Switch
trigger
CAUTION:
• Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
• Switch can be locked in "ON" position for ease
of operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
After connecting the motor unit cord to the outlet in the
handle, move the switch lever to the "ON" position.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.

Speed adjusting dial

For model RF1101 and RD1101 only
The tool speed can be infinitely adjusted between 8,000
and 24,000 rpm by turning the speed adjusting dial
on the top of the tool. Higher speed is obtained when
the dial is turned in the direction of number 6; lower
speed is obtained when it is turned in the direction of
number 1.
This allows the ideal speed to be selected for optimum
material processing, i.e. the speed can be correctly
adjusted to suit the material and bit diameter.
CAUTION:
• If the tool is operated continuously at low
speeds for a long time, the motor will get over-
loaded, resulting in tool malfunction.
• The speed adjusting dial can be turned only as
far as 6 and back to 1. Do not force it past 6 or
1, or the speed adjusting function may no longer
work.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
1
tool.
Installing or removing the bit
CAUTION:
2
• Do not tighten the collet chuck without inserting
a bit, or the collet chuck will break.
3 • When using bit of bigger than 1-1/4" in diame-
ter, install base plate with center hole diameter
2-1/2", replacing the original base plate.
4
First, remove the motor unit from the base as follows.
1. Open the lock lever.
► 1. Lock lever
2. While holding the base, turn the motor unit counterclockwise.
3. Turn it until the pin in the base is disengaged from
the groove in the motor unit. Lift the motor unit free
from the base.
Insert the bit all the way into the collet cone and tighten
the collet nut securely with the two wrenches.
► 1. Wrench 2. Router bit
These routers accommodate the bits with 1/2" diameter
shank. When using the 1/4" diameter shank bit, replace
the equipped collet chuck with the one for 1/4" diameter
shank bit which is provided as the standard accessory.
To remove the bit, follow the installation procedure in
reverse.
5 ENGLISH
1
1
2