Beaba Ballidoo Folleto De Instrucciones página 7

PlEASE rEAd ThE FolloWINg INSTrUCTIoNS
CArEFUllY ANd KEEP For FUTUrE rEFErENCE.
USER INSTRUCTIONS
Inserting the batteries (diagram A)
open the battery compartment (10) while separating it from the body
of the baby nasal aspirator (1), and insert the 2 x lr06 batteries, the
right way round, then close the compartment.
Choice of nozzles
The baby nasal aspirator is supplied with 2 nozzles, one for very
small infants (0-3 months), for tiny nostrils, and a larger nozzles for
bigger babies.
Starting by pressing the electronic switch
- one press: green light for slight nasal congestion.
- Two presses: orange light for heavier nasal congestion.
- When the battery level is too low, the orange light flashes.
Aspiration of secretions
Place the silicone nozzle (3) at the entry of the nostril leaving no air
gap between the nostril and the nozzle. draw in for a few seconds;
the secretions are recovered in the cup (6). Be careful not to draw in
against the wall of the nostril. You can repeat the operation as many
times as necessary.
Separate the terminal section (diagram B)
- Pull the silicone nozzle (3).
- Unscrew the transparent cup (4)
- Unscrew the cup (6) to separate it from the body of the aspirator (1)
- Check that the silicone seal is correctly positioned (5).
- Screw in and assemble the various parts.
Cleaning after use
Terminal part: separate the terminal part from the baby nasal aspirator
(diagram A, B) and rinse the various components in cold water. They
can be sterilized cold. do not sterilize in a microwave oven.