Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
WARNING:
To reduce the risk of re or explosion, do not
operate this vac in areas with ammable gases,
vapors or explosive dust in the air. Flammable
gases or vapors include but are not limited to:
lighter uid, solvent-type cleaners, oil-based
paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not limited to:
coal, magnesium, aluminum, and grain or gun
powder. Do not vacuum explosive dust, ammable
or combustible liquids or hot ashes. Do not use
this vac as a sprayer for any ammable or
combustible liquid. To reduce the risk of health
hazards from vapors or dusts, do not vacuum
toxic materials.
WARNING:
The operation of any utility vac can result in
foreign objects being blown into the eyes, which
can result in severe eye injury. Always wear safety
goggles complying with ANSI Z87.1(or in Canada,
CSA Z94.3)before starting operation.
CAUTION:
To reduce the risk of hearing loss, wear ear
protectors when using the vac for extended
hours or when using it in a noisy area. The unit
is ready for dry vacuuming.
After plugging the power cord into the wall receptacle,
turn the unit "ON" by pushing the switch position
with 1 embossing straps is
the "ON" position.
ON
OFF
4
DRY PICK-UP
1. The lter must always be in correct position to
reduce the risk of leaks and possible damage
to vac. Make sure that the lter is completely
covering the lter cage. Make sure there are
no gaps between the lter and the lid. It is
very important to assemble the lter to the
cage without any possible leaks or tears.
Any leaks will allow the picked up debris
to be blown out of the blowing port and back
into the surrounding environment.
2. When using the vac to pick up very ne dust,
it will be necessary to empty the dust tank and
clean or replace the lter at more frequent
intervals to maintain peak vac performance.
NOTICE:
A dry lter is necessary to pick up dry materials.
If use the vac to pick up dust when the lter is wet,
the lter will clog quickly and be very dif cult to
clean. If the lter gets wet, replace it before
continuing to do dry pickups.
INSTALLING THE CARTRIDGE FILTER
1. With the power head in an upside down position,
slide the cartridge lter down over the lid cage,
push the lter seals against the power head.
2. To remove the lter, pull the lter from the
power head.
3. To clean the cartridge lter, shake or brush off
excess dirt or rinse (from the inside of the lter)
with water, dry completely
(approximately 24 hours) and re-install.
Publicidad
