DeWalt DXV04A Manual De Instrucciones página 7

INSTALLING THE PRE- FILTER
Put the pre- lter in the dust tank, make sure the
pre- lter is completely covering the opening edge
of dust tank, make sure there are no gaps between
the pre- lter and the dust tank.
EMPTY THE TANK
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before emptying
the dust tank.
1. Remove the power head assembly of the
vac by pulling outward on the lid clips
located on each side of the vac. Lift off
the power head assembly.
2. Dump the tank contents into the proper
waste disposal container.
CARE AND MAINTENANCE
WARNING:
To reduce the risk of injury from accidental starting,
unplug power cord before changing or cleaning lter.
The lter should be cleaned often to maintain peak
vac performance.
IMPORTANT:
After cleaning, check the lter for tears or small holes.
Do not use a lter with holes or tears in it. Even a
small hole can cause a lot of dust to come out of
the vac. Replace it immediately.
NOTICE:
Clean the lter in an open area. Cleaning should
be done outdoors and not in living quarters.
CLEANING:
To keep the ash vac looking its best, clean
the outside with a cloth dampened with warm
water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and
mild soap.
3. Wipe out with dry cloth.
STORAGE
Before storing the vac, the dust tank should be
emptied and cleaned. The vac should be
stored indoors.
5
ENGLISH