Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
Cat. No. ..................................................... 2122-20
Ingress Protection............................................ IP56
Battery Type .................................................M18™
Charger Type ................................................M18™
DC Input Volts......................................................18
Recommended Ambient
Operating Temperature ......................0°F to 125°F
SYMBOLOGY
Volts
Direct Current
Read Operator's Manual
Do not stare at the operating light
source
UL Listing for Canada and U.S.
US
C
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Inserting/Removing the Battery
To insert the battery:
1. Lift the battery compartment buckle and open the
battery compartment.
2. Slide the pack into the tool. Make sure it latches
securely into place.
3. Close the battery compartment and relatch the
buckle securely.
To remove the battery:
1. Lift the battery compartment buckle and open the
battery compartment.
2. Push in the release buttons and pull the battery
pack out of the tool.
3. Close the battery compartment and relatch the
buckle securely.
OPERATION
To reduce the risk of injury, do not
CAUTION
stare at the operating light source.
To turn on the light, press the Power button
the MODE buttons to cycle through the three settings
of each light. Rotate the heads to the desired angle.
To turn off the light, press the Power button
NOTE: The light will default to the last selected
brightness the next time it is turned on.
To use the handle clamp, grasp the top handle and
pull out the clamp handle.
WARNING
move the battery pack from the charger or tool be-
fore performing any maintenance. Never disas-
semble the tool, battery pack or charger. Contact a
MILWAUKEE service facility for ALL repairs.
Keep your light, battery pack and charger in good
repair by adopting a regular maintenance program.
If the light does not work properly, return the light to
a MILWAUKEE service facility for repairs.
WARNING
your tool, battery pack or charger in liquid or
allow a liquid to flow inside them.
Clean dust and debris from any vents. Keep tool
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain clean-
ing agents and solvents are harmful to plastics and
other insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household deter-
gents containing ammonia. Never use flammable or
combustible solvents around tools.
WARNING
removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
For a complete listing of accessories, go online to
www.milwaukeetool.com or contact a local distributor.
SERVICE - UNITED STATES
1-800-SAWDUST
Monday-Friday, 7:00 AM - 6:30 PM CST
or visit
Contact Corporate After Sales Service Technical
Support with technical, service/repair, or warranty
questions.
Email: metproductsupport@milwaukeetool.com
B e c o m e a H e a v y D u t y C l u b M e m b e r a t
www.milwaukeetool.com to receive important
notifications regarding your tool purchases.
. Press
Milwaukee Tool (Canada) Ltd
again.
Monday-Friday, 7:00 AM - 4:30 PM CST
or visit www.milwaukeetool.ca
4
MAINTENANCE
To reduce the risk of injury, always
unplug the tool and charger and re-
Maintain Light
To reduce the risk of personal in-
jury and damage, never immerse
Cleaning
ACCESSORIES
Always remove battery pack and
unplug tool before changing or
www.milwaukeetool.com
SERVICE - CANADA
1.877.948.2360
(1.800.729.3878)
Publicidad
