Publicidad
Idiomas disponibles
Idiomas disponibles
Switch housing
Figure 14
Step 7. Remove one of three switch housing
screws on the switch housing and keep for later
use, then loosen the other two.
Motor assembly
Figure 15
7.
Step 8. Connect the 9-pin connectors from the
light kit to the 9-pin connectors from the motor
assembly. Attach the light kit to switch housing
using the two key slots in the light kit. Replace the
screw previously removed on step 7. Tighten all
switch housing screws securely.
Figure 16
Step 9. Insert two MAXIMUM 6W E26 LED
bulbs (included) into lamp holders. Dry your
hands before installing bulbs. Keeping the bulbs
clean is important as useful lifetime of a dirty
bulb could be shorter than a clean bulb.
Light kit
Figure 17
Step 10. Secure the shade to switch housing by
twisting in a clockwise direction. Do not
over-tighten.
Light Control
Pull Chain
LED bulb
Fob
Step 10. Connect the fobs to the appropriate pull
chains as shown in Figure 18.
The fob marked with a fan image is for motor
speed control: High , medium , Low and off. Pull
once for each position.
The fob marked with a lamp image controls the
light, either ON or OFF with each pull of the
chain.
Switch
housing
Shade
Reverse Switch
Fan Control
Pull Chain
Figure 18
Publicidad
