Lenco LBT-225 Manual De Usuario página 11

 Lower tone arm on USB turntable onto album and track you want to record.
 Click on the blue Pause button to pause the recording. Press it again to continue.
 Click on the yellow Stop button.
That's it. You can now play around with your recording and explore the editing capabilities of Audacity. Remember
that you can use the Undo function almost without limits while the project is open.
NOTE: CD's cannot be burned directly from the Audacity application. Other CD burning applications should be used.
Maintenance and Cleaning
1. Do not touch the stylus tip with your fingers. Avoid bumping the stylus on the turntable mat or a record's
edge.
2. Clean the stylus frequently with a soft brush with a back-to-front motion only.
3. Clean the records to get rid of dust or grease with a record cleaning brush and record cleaning solution.
4. Clean the turntable lid and turntable cabinet with a slightly damped microfiber cloth.
Note: Do not use cleanser other that contains alcohol, benzene or any other harsh chemicals, with might damage
the paint and finish of the turntable.
Your turntable requires little of no regular maintenance. Remove dust with a slightly damp antistatic cloth. Never
use a dry cloth, this will create static electricity and attract more dust! Antistatic cleaning agents are available at
specialist stores, but must be applied sparingly to avoid damage to rubber parts. It is recommended to install the
needle cover before cleaning or maintenance is carried out to avoid damage.
If the turntable is not used over a long period of time, the drive belt should be removed to prevent unequal
stretching.
Always disconnect the record player from the power supply as a precaution before maintenance!
Useful Tips
The turntable should be positioned on a low-resonance surface such as wood or multiple layer ply board to avoid
structural vibrations disturbing playback.
Cartridge Replacement
1. Before replacement, put the stylus protector back on the stylus to prevent damage to the stylus during the
replacement process.
2. Carefully remove the wire leads from the original cartridge.
3. Loosen the two screws on the headshell that are securing the cartridge and then remove the original
cartridge.
4. Mount the new cartridge to the headshell and tighten it lightly. Do not completely tighten the screws at this
- 11 -