Publicidad
Idiomas disponibles
Idiomas disponibles
moment.
5.
Connect the wire leads to the new cartridge's terminals. The wire lead color are as below:
White
Blue
Red
Green
6.
Adjust the cartridge's position to make sure it is precisely aligned on the headshell so that the stylus will be
tracking the grooves in parallel perfectly.
To achieve this, place the included paper cartridge alignment protractor over the turntable spindle, carefully lift
the tone arm and place the tip of the stylus on the points marked 130mm and 250mm respectively. Fine tune the
cartridge's position on the headshell until the cartridge is perfectly in parallel with the reference lines at both
posits.
7.
Tighten the screws completely once the perfect alignment is achieved.
Specifications
Main Unit
Power
Power Consumption
Turntable Speed
Speed Variance
Wow and Flutter
Signal to Noise
Downforce Range
Effective Tonearm Length
Overhang
Turntable Dimensions (W X H X D)
Weight
Needle: AT-VM95E
Frequency Response
Channel Balance
Channel Separation
Output Voltage
Recommended Load Resistance
Amplifier connection
Recommended Tracking Pressure
Weight
Note:
•
Design and specifications are subject to change without notice.
Left channel positive
Left channel negative
Right channel positive
Right channel negative
AC power adaptor, DC output 12V 500mA
6W
33 1/3, 45 RPM
±1.0%
< 0.15%
55dB
0-2.2g
8.6" (218.5mm)
0.73"
418 X 123 X 346 mm, with lid open 420 X 410 X 420 mm
6.65kgs
20Hz - 20,000Hz
<2.0dB
>20dB
4.0mV
47kΩ
MM - input
1.8-2.2g
6.1g
- 12 -
(L+)
(L-)
(R+)
(R-)
Publicidad
