Lenco LBT-225 Manual De Usuario página 13

Power supply adaptor:
Manufacturer: BRIGHTPOWER OPTOELECTRONIC TECHNOLOGY CO., LTD
Model number: SW1200500-FM
Input voltage: 100-240V
Input AC frequency: 50/60Hz
Output voltage: DC 12V
Output current: 0.5A
Output Power: 6W
Average active efficiency: 79.62%
Efficiency at low load (10%): 70.40%
No load Power consumption: 0.073W
Use only the power supply listed in the user instructions
Troubleshooting
There is no power
• Power adaptor is not connected correctly.
• No power at the power outlet.
Power is on, but the platter does not turn
• Need to switch the Speed/STOP button to 33 or 45 to start playing.
• Turntable's drive belt is not installed or has slipped off.
• The unit automatically switched in standby mode, power ON again.
Turntable is spinning, but there is no sound, or sound not loud enough
• Stylus protector is still on.
• Tone arm is lift up by the lever.
• The Phono/Line switch is set at PHONO position but RCA jacks connected to the stereo system's line input.
• Forget to connect the speaker to the turntable.
Distorted of inconsistent sound from one or both channels:
- Turntable is connected to wrong input of amplifier.
- Needle or cantilever damaged.
- Drive belt overstretched or dirty.
- Platter bearing without oil, dirty or damaged.
- Dust on stylus.
- MM/MC switch on pre-amplifier set incorrectly.
Record sounds too fast or too slow
• Wrong speed selected for the record.
- 13 -