ProMed tens 1000 s Instrucciones De Empleo página 36

o
36
PeratInG the unIt
C t
onneCtInG the ens
1. Preparing the skin
DE
Prepare the skin as described above and in the instructions that ca-
me with the electrodes. Position the electrodes in the area recom-
EN mended by your doctor.
2. Connecting the leads to the electrodes
Connect the leads to the electrodes before attaching the electrodes
FR
to the skin.
Caution: Make sure that the intensity regulators (B) for both chan-
IT
nels 1 and 2 are in the „OFF" position.
3. Attaching the electrodes to the skin
ES
Attach the electrodes to your skin in the manner recommended by
your doctor.
NL
4. Connecting the leads to the TENS unit
Plug the lead into the appropriate channel socket, pushing the plug
PL as far as possible into the socket (see "Connecting the electro-
de leads").
5. Selecting the settings for treatment
RU
Make sure that the settings selected on the unit are those recommen-
ded by your doctor.
TR
6. Setting channel intensity
The intensity regulator (B) is to be found on the upper side of the
AR
unit. Turn the control knob for channel 1 or 2 in a clockwise direc-
tion. The power LED will light up when the unit is switched on.
u
nIt
Slowly turn the control knob in a clockwise direction until you reach
the intensity setting recommended by your doctor. If both channels
are being used, repeat the same procedure for the other channel.
s C t
KIn are IPs
Effective skin care is especially important in order to
ensure comfortable use of your tens 1000 s unit.
• Always wash the areas of skin where the electrodes are to be
placed using mild soap and water. Thoroughly wash off any
soap remains and carefully dry the skin before using an elec-
trode.
• To ensure effective contact between the skin and the electrode,
excess hair should be cut but not shaved off prior to treatment.
• You may prepare the skin with a skin care product recommen-
ded by your doctor. After applying it, let it dry before attaching
the electrodes as described. This will reduce the likelihood of skin
irritation and prolong the life of your electrodes.
• Avoid excessive pulling of the skin when attaching the elec-
trodes. The best way to achieve this is to place the electrode on
the skin and carefully smooth it out from the centre outwards.
• When removing the electrodes, always pull them off in the direc-
tion of hair growth.
• It may be helpful to apply a skin cream to the area being treated
while the electrodes are not being worn.