MSW Motor Technics MSW-TCM1350-S Manual De Instrucciones página 18

3.2.
INSTALLING THE MACHINE
Products may require partial assembly. Components requiring assembly depend on
the product model selected.
Angle gauge:
- place the angular gauge in the correct position (photo 1)
- tighten the screws (photo 2)
Photo 1
3.3.
1. Nipper selection (for MSW- TCM1350-S)
Work should begin by setting up the correct nipper. The MSW- TCM1350-S has two
options depending on the thickness of the material to be cut:
- for tiles less than 10 mm thick it is recommended to use a small nipper,
Preparations for operation
Operating the machine
Photo 2