MSW Motor Technics MSW-TCM1350-S Manual De Instrucciones página 21

- tighten the screw and make sure again that the arrow points to the correct gauge
setting,
- place the tile on the pads,
- set the stop and tighten the screw (for models MSW-TCM1350-S, MSW-TCM1000-
SM),
- make the cut in the same way as the right-angle cut (described above).
Caution! Please note that the new cuts on the tiles have very sharp edges.
3.4.
a) Do not clean with any sharp and/or metal implements (e.g. a wire brush or a
metal scraper) as these may damage the surface of the appliance.
b) Do not clean the appliance with acidic substances, medical products, thinners,
fuel, oil or other chemicals as they may damage it.
c) When you have finished working, clean the machine by removing tile residue
and dust.
d) Lubricate the guides regularly.
e) Store the device in a dry place. It is recommended to cover the device during
storage.
f) Before each use, check that the device has all components and that they are
working correctly.
Cleaning and maintenance