MSW Motor Technics MSW-TCM1350-S Manual De Instrucciones página 19

- For tiles thicker than 10mm it is recommended to use a larger nipper, for this
purpose the feet of the larger nipper should be turned to the position shown in the
picture below.
2. Cutting a tile at right angle
- place the product on a straight and stable surface,
- make sure that the protractor on the gauge is set to "0". (for models MSW-
TCM1350-S, MSW-TCM1000-SM, MSW-TCM800-D, MSW-TCM1000-D),
- place the tile on the cushioning pads and press against the gauge,
- use the handle to position the blade on the back edge of the tile,
- using moderate pressure, cut the tile in one continuous movement along its entire
length,
- lower the nipper,
- using the main handle, gently push the nipper away from the front edge of the tile,