Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting air tools
•
Tools can be connected to the Quick
Connector (10) using a suitable air line
fitted with a corresponding ¼ bayonet
type male connector
•
Always ensure that air tools are in the
off position connecting. Tools will be
pressurized as soon as the connections
are made
•
To connect an air tool, fit the air line to
the tool, then push the bayonet fitting
into the Quick Connector outlet of the
compressor
•
Once connected, the output pressure
can be adjusted. Turn the Pressure
Regulator (11) clockwise to increase
pressure,
and
decrease pressure. The line pressure is
displayed on the Pressure Gauge (7)
•
Release the air line by pulling back the
outer sheath of the high pressure outlet
and pulling the bayonet fitting out. Be
aware that the air line and tool will hold
residual air pressure.
Adjusting line pressure
•
The pressure of the air supplied to the
tool (line pressure) can be adjusted using
the Pressure Regulator (11). The line
pressure is displayed on the Pressure
Gauge
•
Increase the line pressure by rotating the
pressure regulator clockwise. To reduce
the line pressure, rotate the pressure
regulator anti-clockwise
Description
Work to be
carried out
Motor oil
Check level
Change
Air filter
Inspection
Clearing
Fittings &
Check, tighten &
fasteners
replace if
necessary
Valve
Clearing &
maintenance
clearance
adjustment
WARNING: Maintenance not covered by this manual MUST be carried out by an authorized our
technician. Attempting such maintenance or repairs will void the guarantee.
WARNING: Some of the maintenance procedures described in this manual require some general
technic skills and expertise. This compressor MUST ONLY be serviced by people with the
necessary skill level. If in doubt, have the machine serviced at an authorized our serviced at an
authorized our service center
anti-clockwise
to
Before
After 1
each use
month/first 20
hours
X
X
Maintenance
WARNING:
ALWAYS
personal protective equipment, including eye
protection and oil-resistant gloves, when
carrying
out
maintenance
compressor.
ALWAYS
ventilation.
WARNING:
if
oil
maintenance,
fill
containers and dispose of according to laws
and regulations
WARNING: ALWAYS switch the compressor
off and wait until all components have
completely
cooled,
carrying out any maintenance (with the
exception of oil removal; refer to "Changing
the motor oil")
Note: The maintenance schedule should be
adjusted according to use and environment.
If the compressor is used frequently, and/or if
it is used in harsher environments, shorter
maintenance intervals are required.
WARNING: Always remove the plug from the
mains power supply before carrying out any
maintenance/cleaning
•
Do
not
attempt
maintenance when the air tank is
pressurized
•
Residual air will escape from the valve
until the ring is released, or all air
pressure is released
Every 3
Every 6
months/50
months/100
hours
hours
X
X
wear
adequate
on
this
ensure
proper
is
removed
during
into
suitable
sealed
before
cleaning
to
perform
any
Every
12months/300
hours
X
X
X (requires
qualified
technician)
or
Publicidad
