Ritmo STARGUN LINK Manual De Uso Y Mantenimiento página 17

WARNING! Do not let any electrical wire come into direct
contact with neither the extruded nor the hot surfaces!
LINERS – GEOTEXTILES
If the sheets to be welded are very thin, it is possible to decrease the blower
flow.
Decrease the air temperature below 225°C: the display will show a flashing
'225°C/OFF' while air flow slows down.
225 [OFF]
2
3
At the end of welding, place the extruder on the appropriate support.
SHUTDOWN
Push buttons 6 and 7 together: the air temperature decreases to cool down
the heating resistors, while a countdown starts on the display.
Please wait 97 sec
7
6
CAUTION! The shutdown procedure does not provide for the complete
cooling of the various hot parts of the extruder but only serves to lower the
temperature of the heating resistors to ensure a longer duration. To avoid
accidental burns, wait for the parts to cool naturally.
READY!
215
COOLING
Once the cooling countdown is over, the display shows 'OFF'.
2
3
Push together buttons 2 and 3 to turn on the extruder again or unplug it.
WARNING! Always unplug the extruder at the end of working day.
SETTINGS MENU
Hold down button 2 within 6 seconds from connecting the extruder to the
power source to enter the settings menu.
PLEASE WAIT 120
2
If within 6 seconds you cannot access the menu, disconnect the extruder
from the power source, reconnect it and proceed as described above.
7
6
3
Push buttons 6 and 7 to select the menu number to access. Push button 3
to confirm.
Number 0: it displays the MOTOR working hours (..h: ..m) with partial and
total time counter.
XXH
Total working hours
Partial working hours
Number 1: press button 3 to zero the partial time counter above.
Note: The partial counter registers each sec of MOTOR in use and updates
the display value for each 4 1/2 min of use.
Number 2: use to switch between Celsius and Fahrenheit. Use buttons 6
and 7 to select Celsius CEL or Fahrenheit FAR.
Press button 3 to save the settings.
WARNING! The advanced menus (from 3 on) are for factory settings only
OFF
HEATING
NUMBER?
0
YYH ZZM
EN 17