Ritmo FLOW HD-PRO Manual De Uso Y Mantenimiento página 13

Activation:
Set the mains switch 5 to position 1. Adjust the
temperature using the potentiometer 6, if neces-
sary. The warm-up time for the device is approx
5 minutes.
De-activation:
Turn the potentiometer 6 to position 0 for cooling
down. Once the unit has cooled down, set the
switch 5 to 0.
Maintenance, service and repairs: Check
mains connection lead and plug for breaks and
mechanical damages!
Before commencing with any work on the
device, disconnect the mains plug!
Always keep the device and air intake screens
clean. If necessary, clean the dirty screens with
a brush while the device is switched off. Only
original accessories may be used.
Once the carbon brushes reach the minimum
length, the fan motor
automatically. Have
replaced by an authorized service centre or a
specialist company.
Repairs on the device should only be performed
by an authorized repair shop.
Technical Data:
Nominal voltage
range:
Frequency range:
Output:
Output temperature:
Noise emission level:
Protection class:
Weight:
will switch off
the carbon brushes
120 V or 230 V~
50Hz - 60Hz
120 V 1650 W or
230 V 1500 W
≤ 700°C
< 70dB
II /
(double insulated)
1.4 kg including mains
connection lead
Disposal
Do not dispose of in the household trash.
Add the device that is no longer able to be
used to a separate collection for the pur-
pose of environmentally friendly recycling.
Help in the event of problems:
S.p.A.
via A. Volta, 35/37 - Z.I. Selve
35037 BRESSEO DI TEOLO (PD)
ITALY
Tel. +39.049.990.1888
Fax +39.049.990.1993
service@ritmo.it
EU Declaration of Conformity
Ritmo S.p.A.
via A. Volta, 35/37 - Z.I. Selve
35037 BRESSEO DI TEOLO (PD)
ITALY
Model name: FLOW HD-PRO
agrees with the requirements of the following
European Directives:
EU Directive 2006/42/EU - NSR
EU Directive 2014/30/EU - EMC
EU Directive 2014/35/EU
2011/65/EU ROHS-2
The concurrence of the specified product with
the requirements of Directive 2006/42/EU is
proven by the observance of the following stan-
dards:
EN 60335-1:2002 + A11:2004 + A1:2004 +
A12:2006 + Corrigendum:2006 + A2:2006
EN 60335-2-45:2002
EN 50581-2012
the last two digits of the year in which the CE
marking was attached: 17
The concurrence of the specified product with
the requirements of Directive 2014/30/EU is
proven by the observance of the following stan-
dards:
EN 55014-1:2006 + A1:2009 + A2:2011
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
EN 60335-2-45:2002
Operating Instructions EN
13