Publicidad
Idiomas disponibles
Idiomas disponibles
19x
Dent removal tabs
5x
Dent removal attachments
6x
Knock down tips
1x
Casing
6.1.3. 10061542 & 10061543
1x
Dent lifter
1x
Glue gun
10x
Glue sticks
18x
Dent removal tabs
6.2. Requirements for the location of installation
Install the product in a location that meets the following requirements:
•
Dry environment.
•
Away from heat sources and highly inflammable liquids at a minimum distance of 1 meter.
Near a power outlet.
•
•
Easily accessible by the end user.
7. Use
7.1. Before use
1. Fill the spray bottle [#] with rubbing alcohol.
2. Spray some rubbing alcohol with the spray bottle [#] on the area with the dent to degrease
the body panel.
3. Wipe the body panel dry with a soft, dry cloth.
4. Remove any glue residue from the dent removal tabs [#].
7.2. Switching on and starting up
•
Fire hazard caused by short-circuiting. Always check if the voltage stated on the type plate of
the product matches with the power outlet voltage.
•
Electrical shock hazard caused by short-circuiting. Always connect the power cable to a
grounded power outlet.
•
Fire hazard caused by the product that can become hot during use. Never use the product
near flammable materials or surfaces. Always keep the product at a minimum distance of 1
meter from flammable materials or surfaces.
1. Insert a glue stick [#] in the glue gun [#].
2. Plug the power cable [#] into a power outlet.
The glue gun [#] is now switched on.
3. Allow the glue gun to heat up for approximately 3 – 5 minutes.
9
Publicidad
