MSW Motor Technics MSW-DA-12 Manual página 31

• Using the bridge puller [#]:
1. Rotate the bridge puller knob [#] slowly counter clockwise to lift the dent.
2. Repeat until the dent is fully lifted.
• Using the dent lifter [#]:
1. Adjust the dent lifter knob [#] to adjust the lifting strength.
2. Squeeze the two handles of the dent lifter [#] together to lift the dent.
3. Rotate the dent lifter [#] clockwise to differ the support points on the body panel
and to evenly lift the dent.
4. Repeat step 2 and 3 until the dent is fully lifted.
8. Remove the T-Bar [#], bridge puller [#], or dent lifter [#] from the dent removal tab [#].
9. Spray some rubbing alcohol with the spray bottle [#] onto the dent removal tab [#] to
release the dent removal tab [#] from the body panel.
10. Carefully remove the dent removal tab [#] by hand or with the scraper [#] from the body
panel.
11. Wipe the body panel dry with a soft, dry cloth.
12. Inspect the area of the dent. If a smaller dent is left on the body panel, repeat steps 1 to 11
again with a smaller dent removal tab [#] until the dent is completely removed.
12