Publicidad
Idiomas disponibles
Idiomas disponibles
2.1. Electrical safety
a)
The device plug must fit into the socket. Do not modify the plug in any way.
Original plugs and matching sockets reduce the risk of electric shock.
b)
Do not touch the device with wet or damp hands.
c)
Do not use the cable in a wrong way. Never use it to carry the device or to pull
the plug out of the socket. Keep the cable away from heat sources, oil, sharp
edges or moving parts. Damaged or tangled cables increase the risk of electric
shock.
d)
If you cannot avoid using the device in a wet environment, use a residual
current device (RCD). Using an RCD reduces the risk of electric shock.
e)
Do not use the device if the power cable is damaged or shows clear signs of
wear. A damaged power cable should be replaced by a qualified electrician or
the manufacturer's service.
f)
To avoid electric shock, do not immerse the cable, plug or device itself in water
or other liquid. Do not use the device on wet surfaces.
g)
Do not use the device in high humidity rooms or in a direct vicinity to a water
tanks!
h)
The device must not get wet. Risk of electric shock!
2.2. Safety in the work area
a)
Keep the work area tidy and well lit. Disorder or poor lighting can lead to
accidents. Be careful, watch what you are doing and use common sense when
working with the device.
b)
Do not use the device in an area with a risk of explosion, for example in the
presence of flammable liquids, gases or dust. The device produces sparks
which can ignite dust or vapours.
c)
In the event of damage or malfunction of the device, it must be switched off
immediately and the incident must be reported to an authorised person.
d)
If in doubt as to whether the product is working properly or if you detect
damage, contact the manufacturer's service.
e)
Repairs of the product may only be carried out by the manufacturer's service.
Do not carry out repairs yourself!
f)
If in doubt as to whether the device is working properly, contact the
manufacturer's service.
g)
Repairs to the device may only be carried out by the manufacturer's service.
Do not carry out repairs yourself!
h)
In the event of fire or fire, use only powder or snow (CO2) extinguishers to
extinguish fire in the device where there is voltage.
i)
No children or unauthorised persons are allowed in the work area. (Lack of
attention may result in loss of control over the device).
j)
Use the device in a well-ventilated room.
Publicidad
