Bowers & Wilkins CDA-4D Manual De Instrucciones página 10

7.1.2 Identification Mode
When this option is switched ON the front power
LED will start flashing (White) to indicate which
amplifier you are programming.
7.1.3 Network
DHCP ON / OFF
CDA-4D's factory default setting has DHCP
(Dynamic Host Connection Protocol) set to ON.
DHCP shows the current IP address used when
DHCP is ON. When DHCP is set to OFF this allows
you to enter a desired static IP address.
If changing the IP address or the Subnet
Mask, the new IP address will need to be
entered into the web browser to see the
amplifier's web portal settings again.
7.1.4 Power Mode
In this section, the user can select from a
selection of POWER MODE options.
Note: When an audio signal has not been
present on a channel for 15 minutes,
the amplifier will go into Standby mode.
CDA-4D's factory default setting is set
to Auto Detect.
ON
In this mode, signal sense and 12V Trigger are
turned off. The amplifier will always stay on.
AUTO DETECT
This mode uses signal sense to turn the amplifier on.
12V TRIGGER
In this mode, the amplifier will turn on when a 12V
signal is detected, and turn off when not.
During setup it is strongly recommended that
you keep the POWER MODE method set to
ON to prevent the amplifier from shutting off.
Auto On Delay
The amplifier can be set from 0-20 seconds, this is
useful when you want a series of amplifiers to switch
ON in a specific sequence.
Wake On Lan
This allows the amplifier to be powered on or
awakened from standby, from another device on
a network.
Recommend keeping Wake on Lan
switched ON. When OFF, IP commands
will not be available.
Power Mode
On
Auto Detect with Wake on Lan OFF
12V Trigger with Wake on Lan OFF
Auto Detect with Wake on Lan ON
12V Trigger with Wake on Lan ON
Power in Network
standby Communication in
Mode Standby Mode
N/A N/A
0.5W NO
0.5W NO
0.5W YES
0.5W YES
10