Bowers & Wilkins CDA-4D Manual De Instrucciones página 19

7.3.4.b DSP Settings for third party products
Output Tab
Select output tab to make adjustment to
speaker settings for each output.
EQ Graph
The EQ graph reflects the changes
to the EQ Parameter.
EQ Parameter
The CDA-4D features an 8 band parametric EQ.
Adjustments made to the EQ will be displayed on the
output frequency response graph with the following
configurable settings:
EQ On/Off
Use On/Off button to switch the frequency band to
activate the frequency bandwidth applied.
Frequency Hz
Enter the center frequency (20Hz - 20kHz)
or the filter to be adjusted.
EQ – Q
The Q factor controls the bandwidth that will be
boosted by the equaliser. The lower the Q factor,
the wider the bandwidth. The higher the Q factor,
the narrower the bandwidth.
EQ Gain
EQ Gain increase or decrease the gain
at selected frequency.
Filter Type
Filter Type available: Parametric, High Shelf
or Low Shelf.
Crossover
This is where High Pass (HP) or Low Pass (LP)
crossover filters can be applied.
Crossover
Crossover available: Off, High Shelf or Low Shelf.
Frequency
This is a user input field for the centre point in
the crossover frequency bandwidth applied.
Filter Order (dB/Oct)
Filter Order selectable between -6dB, -12dB,
-18dB, -24dB or Off.
Save / Reset
To apply the EQ and Crossover configuration
made on the channel, click Save before
moving to the next tab.
To restore to default setting or clear setting
made to this section, click the Reset button.
Phase
Phase default is set to OFF, when turned ON,
Phase will invert at 180°.
Delay
Delay is shown in milliseconds, feet or meters.
When a number is entered in any of the three fields,
the other fields will be calculated automatically.
The minimum delay is 0.01 milliseconds, and the
maximum delay is 20 milliseconds.
19