Beper P206VEN650 Manual De Instrucciones página 13

Ceiling Fan with LED Light Use Instructions
Installation Fig.A
The installation of the fan must be carried out by qualified and specialized technical personnel – con-
tact your electrician for further assistance.
Remove the ceiling bracket from the fan, unfastening the 4 screws with a Phillips screwdriver (not provided).
Using the holes found on the bracket as guide, drill the holes on the ceiling making sure thy are deep enough
to fit the ceiling anchors.
The fan must be installed at least 2,3 m from the floor (2,3 m are calculated from the floor to the lower side
of the fan).
Warning: if the fan is installed on plasterboard or wooden ceilings or false ceilings, use plugs and
screws suitable for these materials.
Install the bracket to the ceiling with the screws provided. Then proceed to connect the fan to the power
supply as shown in Fig.A.
Once the connection is set up, insert the fan on the bracket previously installed on the ceiling, and fasten the
fan to the bracket with the 4 screws previously removed.
Make sure that the screws are well fastened, and that the fan is securely fixed to the ceiling.
Operation FIg.B
To activate the remote controller, insert the 2 alkaline batteries type AAA (not provided) inside the battery
case, making sure to respect the polarity indicated.
To activate the LED light, press the ON/OFF key; the color (warm, neutral, cold) can be selected by pressing
the color selection key – the light intensity will be at max level.
For each light color, the light intensity can be adjusted by pressing the increase/decrease intensity key; it is
also possible to gradually change the light color, by pressing the color dimmer key.
Select the fan speed by pressing the relevant key related to the desired setting (low speed, medium speed or
high speed). Press the fan OFF key to stop the rotation of the blades.
To activate the automatic switch off timer, press the relevant key for the desired setting (1h­2h­4h); when the
timer goes off, the fan and the light will automatically shut off.
Night mode can also be selected: fan speed stays on low, while the LED light is set on the lowest intensity
level and warm color; to activate this mode, press the relevant key on the remote controller.
Cleaning and maintenance
Make sure the appliance is switched off before carrying out any cleaning operation.
Remove dust or stains from the outer surface using a soft dust cloth, or a soft cloth slightly dampened.
Warning: do not let water or other liquids penetrate inside the fan; do not spray water or other
liquids directly on the fan.
Remove batteries from the remote controller if not used for long periods of time.
Technical data
LED light power: 40W
Fan power: 40W
220­240V 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without
any notice.
13
EN