Ryobi P2800 Manual Del Operador página 15

CLEANING THE UNIT
See Figure 12.
WARNING:
Always store and dispose of chemicals properly. Disposal
of contaminated rinse water should be performed
according to local ordinances and bylaws.
DRAINING THE TANK
If there is any liquid left in the tank after spraying, the tank
should be drained before cleaning.
 Remove the battery pack.
 Remove the motor housing from the tank by lifting up
and releasing the latches on each end of the unit.
 Drain the contents through the fill area.
NOTE: Drain the contents back into the original container.
Do not store chemicals in the tank.
CLEANING THE TANK
 Fill the tank about one-third full with clean water. A small
amount of mild household detergent may be added.
NOTE: Never use flammable chemicals or abrasive
cleaning agents to clean the tank.
MAINTENANCE
 Wipe the outside of the tank with a clean, dry cloth.
 Reattach the motor housing to the tank. Make sure the
 Reinstall the battery pack. Spray until the tank has been
 Refill and repeat the procedure with clean water. It may
 Allow all pieces to completely dry before reinstalling parts
CLEANING THE NOZZLE
See Figure 13.
If the nozzle becomes plugged, use the steps below to clear.
 Remove the battery pack.
 Unscrew and remove the nozzle from the spray wand.
 Push a small wire through the cross holes to clear any
 Wipe the nozzle and cross holes with a clean dry cloth
11 — English
latches are closed.
emptied. Make sure to direct the spray toward an area
that will not be damaged by the spray solution.
be necessary to rinse the tank more than once, then drain
again as directed above.
and storing the unit.
debris. If necessary, rinse the cross holes and nozzle with
clean water.
and reinstall the nozzle.