Publicidad
Idiomas disponibles
Idiomas disponibles
EN
34
Control panel
1
2
1
Start/Stop button
2
Light button
3
Compressor operation indicator
4
Digital display of the temperature in the upper zone
5
Digital display of the temperature in the lower zone
6
Setting button for the upper zone
7
Setting button for the lower zone
USAGE
Starting up the device
Once the wine cabinet is properly installed, we advise that you clean the inside
using warm water with a low concentration of dishwashing liquid. Do not use
abrasives or scouring powder; they may scratch the surface finish.
•
Your wine cabinet is ideally suitable for holding Bordeaux type bottles of
0.75 L capacity. It can contain larger bottles; however care must be taken that
they do not prevent the door from closing properly.
•
When closing the door ensure that it does not touch any of the bottles.
•
If you load several bottles at a time, it will take longer before the cabinet
reaches the desired temperature.
•
In order to avoid damaging the door seal, ensure that the door is fully open
before moving the racks along the compartment rails.
•
Starting the appliance
Press the start/stop button for about 3 seconds.
Do the same to turn it off.
Temperature control
Press and hold the temperature setting button for three seconds to display the
actual temperature, and press any button to return to display the set temperature.
The internal temperature is regulated by the electronic thermostat controlled by
the buttons inside the appliance.
3
C
3s
4
6
C
5
7
Publicidad
