Klarstein BAROSSA 123 DUO Manual De Instrucciones página 35

Each time the "upper zone" or "lower zone" key is pressed, the selected zone is
incremented by one degree. To obtain a temperature lower than the one indicated,
You can adjust the temperature degree by degree.
After the temperature is selected, the display will flash for 5 seconds and display
the set-point temperature.
Control of the light
To turn on or off the internal light, press the button.
The (LED) light is suitable for the conservation of wine. In order to reduce energy
consumption, the LED light goes off automatically after 10 minutes. However,
we recommend turning off the light under normal use or after each use. However,
if you wish to leave the light on, the procedure is as follows; press button 2 for at
least 5 seconds; the display will then show "LP".
After a few seconds, the display comes back to the temperature indication and the
light stays on continually. To return to the light turning off automatically after 10
minutes, press button 2 for at least 5 seconds; the display will then show "LF". After
a few seconds, the display comes back to the temperature indication and the light
goes off automatically.
Temperature recollection function
In the event of a power interruption, the wine cabinet remembers the previous
temperature settings. When the power is recovered, the cabinet temperature will
go back the same setting temperature prior to powering off.
Temperature alarm
If internal cabinet temperature is higher than 23°C, "HI" is shown in the display
panel, and the alarm sounds after one hour continuously to warn that the inner
temperature is too high.
If internal temperature is lower than 0°C, "LO" is shown in the display panel and
the alarm sounds after 15 minutes to warn the inner temperature is too low.
Notes
• If the unit is unplugged, power lost, or turned off, you must wait 3 to 5
minutes before restarting the unit. If you attempt to restart before this time
delay, the Wine cooler will not start.
• When you use the Wine cooler for the first time or restart the Wine cooler
after having been shut off for a long time, there could be a few degrees
variance between the temperature you select and the one indicated on the
LED readout. This is normal and it is due to the length of the activation time.
• Once the Wine cooler is running for a few hours everything will be back to
normal.
EN
35