Climit GG E 3 Manual Del Usuario página 31

surfaces and the smoke evacuation tube
well, removing any deposits.
Once the maintenance is compled, the
baffles have to be fitted onto the original
positions (ref. "GG E 3-4-5-6" models).
The maintenance operations can be car-
ried out without removing the burner.
3.3.2 Disassembly of the casing
To disassemble the casing of the boiler,
proceed as follows (fig. 10):
– remove the cover (12) fixed with pin
clutches;
– remove the panel (8) which are fixed to
the sides by pin clutches;
– remove the control panel (9) whose
sides are fixed by four self-tapping
screws;
2
– remove the back panels (6) and (7)
which are fixed to the sides by ten self-
tapping screws;
– disassemble the left side (3) un-
screwing the screws fixing it to the up-
per bracket (5), and remove the screws
that fix it to the lower bracket (1);
– disassemble the right side (4) fol-
lowing the same operations.
3.3.3 Fault finding
Herefater we outline a number of poten-
tial problems that may occur on the
appliance and the relevant list of actions
required.
A working fault, in most cases, provo-
cates the "lock out" signal onto the con-
trol panel of the control box.
6
7
11
1
9
3
When this light turns on, the burner can
operate again only after the reset button
has been pressed; if this has been done
and a regular ignition occurs, it means
the failure can be defined momentary
and not dangerous.
On the contrary, if the "lock out" stays,
the cause of the fault, as well as the rel-
evant action must be made according to
the following chart:
The burner does not ignite
– Check the electric connections.
– Check the regular fuel flow, the clean-
ness of the filters, of the nozzle and air
vent from the tube.
– Check the regular spark ignition and
the proper function of the burner.
The burner ignites regularly but the
12
4
5
9
8
1
Fig. 10
29