Sauder Cannery Bridge Serie Instrucciones De Montaje página 15

Step 11
Unfold the BACK (F) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (F).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHT (C).
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
www.sauder.com/services
F
420334
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(39 used in this step)
These holes must line up
over the UPRIGHT (C).
1N
NAIL
Page 15