Sauder Cannery Bridge Serie Instrucciones De Montaje página 19

Step 15
Before fastening the DOOR to your unit, be sure the mounting screw is against the
å
stops as shown in the right diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten a DOOR (G) to the LEFT END (B) as shown in the lower diagram. Use
å
the screws in the HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Insert two BUSHING CONNECTORS (32F) into the holes in the DOOR MOLDING (P).
å
NOTE: Be sure to insert the BUSHING CONNECTORS exactly as shown.
å
Fasten the DOOR MOLDING (P) to the DOOR (G). Use two SILVER 3/4" MACHINE
å
SCREWS (20S) through the DOOR, through the BUSHING CONNECTORS, and into
the MOLDING.
Fasten a PULL (101K) to the DOOR (G). Use two GOLD 1" MACHINE SCREW (50S)
å
through the DOOR, through the DOOR MOLDING, and into the PULL.
Peel a FELT DISC from the FELT DISC CARD (1M). Stick a
å
FELT DISC on the DOOR (G) where it comes in contact with the UPRIGHT (C).
Repeat this step for the other DOOR (G).
å
See the next step for DOOR adjustments.
å
P
101K
32F
www.sauder.com/services
32F
1M
G
1M
GOLD 1" MACHINE SCREW
(4 used for the PULLS)
B
C
50S
420334
Mounting
screw
Hinge
20S
SILVER 3/4" MACHINE SCREW
(4 used for the BUSHING CONNECTORS)
Stop
Page 19