Bastilipo Mistral Manual De Instrucciones página 5

Instructions manual
• Dear customer, We thank you very much for
having purchased one product of ours. We
kindly ask you to read and save this instruction
manual.
• Warning: TO reduce the risk of fire or electrical
shock, DO NOT USE THIS FAN with any SOLID
STATE Speed Control Device.
• When using electrical appliances, basic safety
precautions should always be followed including the
following:
1. Use this fan only as described in this manual,
other use not recommended may cause fire, electric
shock or injury.
2. High Velocity fans are designed to create rapid
air movement, therefore make sure the fan is not
placed near drapes, curtains or any objects that
may be drawn into the fan inlet.
3. To protect against electrical shock, do not
immerse unit, plug or cord in water or spray with
liquids.
4. This appliance is not intended for use by children
or other persons without assistance or supervision if
their physical, sensory or mental capabilities
prevent them from using it safely. Children should
be supervised to ensure that they do not play with
the appliance.
5. Unplug the fan from the outlet when not in use,
when moving fan from one location to another,
servicing and before cleaning.
6. Children should be supervised to ensure that
they do not play with the appliance.
7. Do not place the fan or any parts near an open
flame, cooking or other heating appliance.
8. Avoid contact with moving fan parts.
9. To disconnect, grip the plug and pull it from the
wall outlet, never yank the cord.
10. Always use on a dry level surface.
11. Do not hang or mount fan on a wall or ceiling.
12. Do not operate the fan without protective front
and rear grilles in position.
13. Be careful not to place the fan too close to the
edge of the surface.
14. Do not use outdoors.
15. Do not let the power cord hang over the edge of
a table or counter or let is touch any hot surfaces.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
Main components
A. Front Grill
B. Front and rear cover connecting ring
C. Blade
D. Rear grill
E. Motor housing
F. Elevation shaft
G. Supportor board
Operating instructions
1. Set your fan on wall.
2. Plug the power cord into a standard 220V wall
outlet.
3. To operate your fan, turn the control knob to the
desired fan speed Low(1),Med(2)High(3)
4. Adjust the fan head to your desired angle.
Head Assembly
STEP1:Unscrew the 4 lock screw on the face of
the fan housing, handle the rear grill to the motor
housing by matching its 4 screw hole to the 4
screw hole on the front motor housing, then screw
the lock screw to lock the rear grill and the front
motor housing.
STEP2:Insert the motor shaft into the fan blade
by matching the motor shaft spindle to the D-
shaped cut-out on fan blade, then screw the lock
screw.
STEP3:Center the front grill, aligning the logo, so
it is horlzontal and parallel to the floor, place onto
the rear grill, and snap in place. Secure by
tightening the grill button screw at the bottom of
the rear grill.
3
English