Publicidad
Idiomas disponibles
Idiomas disponibles
Change the
Door
·If necessary, the door can be changed from right
to left-hinged.
·Warning! Before you work on the appliance,
always pull the mains plug out of the point
·In order to avoid damages to persons and proper-
ty, execute the change of the door stop with
two persons.
·We recommend leaving the change of the door
stop to experts.
·Before you start with the modifications, here is
some general info:
-Always pay attention to the number of shims
on the bearing pins and screws.
-Position the doors always so that they close
tightly.
a) Unscrew the cover of the door hinges and
remove it.
b) Unplug the cable. Unscrew the 4 screws that
hold the upper hinge and remove it. Take off the
loop on the ground cable of the hinge. Insert the
cable connection in the opening on the top of the
appliance. Take off the door jack and the cover of
the small end caps.
c) Put the door jack and the cable connection in
the opening on the door and then attach the
small end cap.
Stop
Step1
d) Loosen l screws as shown in the figure below, in
order to remove the gap caver on the top side of
the appliance. Remove the small end cap cover
on the door and take out the door socket and the
cable connection.
e)Put the door socket in the round opening on the
door and attach the small end cap cover.
f)Raise the refrigerator door about 50 mm, in order
to remove it from the appliance.
a)Loosen the 3 screws that hold the middle hinge
and then remove it.
b)Raise the freezer door about 50 mm, so you can
remove it from the fridge.
c)Remove the adjustable front stands below the
Step 2
Publicidad
