Kohler PARIGI K-2175 Manual De Instrucciones página 2

TOOLS AND MATERIALS
REQUIRED
S
Level
S
Drill with assorted bits
S
Socket wrench and assorted sockets
INSTALLATION
S
Rough-in the supplies and drain
piping and trap.
NOTE: The supply stop handles cannot
extend more than 3-1/2" (8.9cm) from the
finished wall when in the open position.
S
Install sufficient backing behind the
finished wall to provide a secure
material for the anchoring devices.
S
Apply six self-adhesive
(provided) to the top edge of the
pedestal.
S
Mark the centerline on the floor.
S
Position the pedestal on the floor
centerline so the mounting hole is
approximately 6-13/16" (17.3cm) from
the finished wall.
S
Carefully set the lavatory on the
pedestal.
S
Move the pedestal as required to
ensure proper fit in the desired
location.
S
Level the lavatory.
self-adhesive gaskets as needed to
level the lavatory.
NOTE: The lavatory
supported by the pedestal.
S
Check the lavatory placement.
S
Mark the center of each anchoring
hole on the wall, and mark the floor
through the hole in the pedestal
bottom.
S
Carefully remove the lavatory from
the pedestal. Then move the pedestal
from the area.
A
1010422-2-
S
Tape measure
S
Framing square
Gasket
gaskets
Finished
Wall
Add more
Anchoring
Holes
must
be
2 Kohler Co., Kohler, WI U.S.A.
Top of Pedestal
Pedestal
Mark Floor
Here