Kohler PARIGI K-2175 Manual De Instrucciones página 3

S
Drill a 1/4" mounting hole at the mark
on the floor, then drill two 1/4" hanger
bolt holes at the marks on the wall.
S
Mount hanger bolts to the wall so
approximately 3/4" (2cm) of each bolt
remains exposed.
NOTE: Other fastening devices of
sufficient size and strength may also be
used.
S
Install the faucet and drain to the
lavatory according
manufacturer's instructions.
NOTE: Do not fully tighten slip-joint
drain connections at this time.
S
Position the pedestal mounting hole
over the hole in the floor.
S
Secure the pedestal to the floor with
the wood screw and washer. Tighten
the screw until it is snug.
CAUTION: Risk of
damage. Do not
Overtightening may cause damage to
the product.
S
Set the lavatory on the pedestal so the
hanger bolts extend through the
lavatory holes.
S
Level the lavatory.
S
Install the cap nuts and washers, and
tighten until snug.
CAUTION: Risk of
damage. Do not overtighten the cap
nuts. Overtightening may cause
damage to the product.
S
Connect and tighten the trap to drain.
Connect the hot and cold water
supplies to the faucet.
Kohler Co., Kohler, WI U.S.A.
Hanger
Bolts
to the
product
overtighten.
Hanger
Bolts
product
Pedestal
3
Finished Wall
Pedestal
Wood Screw
Washer
Finished
Wall
Lavatory
Cap Nut
Washer
A
1010422-2-