Publicidad
Idiomas disponibles
Idiomas disponibles
CONSTRUCTION OF THE HEATER
1.Piezo Ignition
2.Control knob
CONNECTING THE CYLINDER
1. Place the gas filled cylinder into the back of the heater.
2. Clip on the gas regulator to the gas cylinder.
3. Turn the regulator on.
4. Please contact your gas dealer to advise of the correct type for the gas cylinder being used.
5. IMPORTANT TEST FOR LEAKS:
This must be carried out in a well ventilated area, free from naked flames and any other sources of
ignition. With the regulator connected to the cylinder turn on the regulator control. Brush all hose
connections, pipe connections to the valve and gas cylinder with a 50;50 solution of detergent and
water or a leak detection spray. A stream of bubbles forming indicates a leak. If a leak is found turn
off at the regulator and disconnect the regulator from the bottle and remove the gas cylinder
outdoors or to a well ventilated area. Contact your gas supplier for assistance. DO NOT USE THE
HEATER
3.Rear Cover
4.Catalytic panel
26
5.ODS
6.Wheel
Publicidad
