Publicidad
Step 16
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (I) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten two KNOBS (95K) to the DOOR (I). Use two
å
BLACK 7/8" MACHINE SCREWS (37S).
Push the DOOR STOP (4I) into the hole in the RIGHT END (A2).
å
See the next step for DOOR adjustments.
å
95K
37S
BLACK 7/8" MACHINE SCREW
(2 used in this step)
Page 20
B
I
4I
A2
415910
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
www.sauder.com/services
Publicidad
