Publicidad
Step 18
1
D132
S
Groove
Insert the DRAWER SIDES (D132 and D138) at an angle
å
into the slot at each end of the DRAWER FRONT (S).
3
Fasten the DRAWER BACK (D159) to the DRAWER
å
SIDES (D132 and D138). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D969) inserts into
å
the groove of the DRAWER BACK (D159).
Page 22
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D138
D159
D132
D969
VIEW THE T-LOCK BOX VIDEO
2
D132
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D969) into the grooves in the
å
DRAWER SIDES (D132 and D138) and DRAWER FRONT (S).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D138
415910
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D969
S
D138
30S
(4 used in this step)
www.sauder.com/services
Publicidad
