Publicidad
STEP 2C
4
POSITION TEMPLATE
06
To calculate your precise wall plate location, check out our
TIP:
HeightFinder at sanus.com [www.san.us/1173].
Place the wall plate template
at your desired height and position the slotted holes over
06
your stud center lines. Level and mark the hole locations.
16
(continued)
Visit
HeightFinder™
www.
san.us/1173
5
DRILL
4X
06
CAUTION:
Be sure you drill into the CENTER of the stud.
Drill the four pilot holes using a 1/2 in. (13 mm) diameter drill bit.
IMPORTANT:
Pilot holes must be drilled to a depth of 1 in. (2.54 cm).
Remove the wall plate template and discard.
1 in. (2.54 cm)
1/2 in.
(13 mm)
Publicidad
