Publicidad
Idiomas disponibles
Idiomas disponibles
Converting to Stroller Mode
1
Pull fork as shown, then rotate wheel
down fully. Fork will automatically
secure into the locked position.
Converting to Trailer Mode
WARNING
StroLLEr WHEEL MuSt ALWAYS BE
FoLdEd uP And ProPErLY LocKEd
Into trAILEr ModE, BEForE PuLLInG
BEHInd A BIcYcLE. FAILurE to PoSItIon
StroLLEr WHEEL In trAILEr ModE
BEForE cYcLInG couLd rESuLt In An
AccIdEnt And SErIouS InJurY or dEAtH.
note
the black tab that extends from the stroller mount towards the
flex connector is not a lever. It is a safety mechanism to prevent
the attachment of the trailer to a bicycle while the stroller wheel
is in its downward (strolling) position.
d'LItE X
2
Adjust tow bar into the strolling position by
removing the retaining pin and pulling on the
receiver release handle, sliding the tow bar
in towards the trailer until it locks into place,
and then re-installing the retaining pin.
1
Pull fork down and rotate up into trailer mode
as shown. Fork will automatically lock into
trailer position when positioned correctly.
ENG
DEU
FRA
ESP
Attaching the Jogging Tether
1
Wrap the strap around the handlebar
center, slide the larger loop through
the smaller loop on the other end of
the strap and pull to tighten securely.
2
Adjust tow bar into trailer position by removing
the retaining pin and pulling on the receiver
release handle, sliding the tow bar out away
from the trailer until it locks into place, and
then re-installing the retaining pin.
ASSEMBLY & uSE
11
Publicidad
