Hilti DX 2 Manual De Instrucciones página 25

3 Description
3.1 Use of the product as directed
The tool is designed for professional use in fastening applications where nails, threaded studs and composite fasteners
are driven into concrete, steel and sand-lime block masonry.
The tool is for hand-held use only.
Modification of the tool is not permitted.
The tool may not be used in an explosive or flammable atmosphere unless it has been approved for use under these
conditions.
To reduce the risk of injury use only genuine Hilti fasteners, cartridges, accessories and spare parts or those of
equivalent quality.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
The tool may be operated, serviced and repaired only by trained personnel. This personnel must be informed of any
special hazards that may be encountered.
As with all powder-actuated fastening tools, the tool, cartridges and fasteners form a technical unit. This means that
trouble-free fastening with this system can be assured only if the Hilti fasteners and cartridges specially manufactured
for it, or products of equivalent quality, are used. The fastening and application recommendations given by Hilti apply
only when these conditions are observed.
3.2 Range of fasteners available for various applications
Fasteners
Ordering designation
X-U
X-C
X-S
X-CT
X-CR
X-CF
X-FS
X-SW
X-HS / X-HS-W
X‑CC
X-(D)FB / X-EMTC
X‑EKB
X-ECH
X‑ET
X-(E)M/W/6/8
Cartridges
Cartridge type
6.8/11 M green
6.8/11 M yellow
6.8/11 M red
Application
High-strength nail for fastening on high-strength steel and concrete in a wide range of
applications
Standard nail for fastening on concrete
Standard nail for efficient fastening on steel
Easily removable nail for fastening formwork temporarily on concrete
Stainless steel nail for fastening in damp or corrosive surroundings
Special fastener for timber structures on concrete
Fastener for positioning formwork
Flexible washer fastener for fastening plastic sheeting and thin insulating materials to
concrete and steel
Suspension system with threaded connection
Fastening clip for wire hangers
Metal conduit clip for fastening electrical conduits or insulated pipes (hot or cold) in
water supply and heating installations
Cable clasp for fastening electric cables flat on ceilings and walls
Bunched cable holder for fastening cables on ceilings and walls
Fastener for plastic (PVC) electric cable trunking
Threaded stud for fastenings on concrete and steel
Color
green
yellow
red
Power level
light
medium
heavy
en
19