Publicidad
Idiomas disponibles
Idiomas disponibles
Variable Speed Controlled
Trigger Switch
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON"
or "OFF" by squeezing or releasing the trig-
ger. The speed can be adjusted from the
minimum to maximum nameplate RPM by the
pressure you apply to the trigger. Apply more
pressure to increase the speed and release
pressure to decrease speed (Fig. 1).
Forward/Reversing Lever
& Trigger Lock
To reduce the risk of ac-
cidentally
tool "ON" when it is not being used, place
the reversing lever in the center trigger lock
"OFF" position. Unintended tool start, may
cause injury or property and tool damage.
Do not change direction
of rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
Your tool is equipped with a forward/revers-
ing lever and trigger lock (10) located above
the trigger (Fig. 6). This lever was designed
for changing rotation of the bit, and for lock-
ing the trigger in an "OFF" position.
For forward rotation, (with chuck pointed
away from you) move the lever to the far left
(Fig. 6).
For reverse rotation move the lever to the far
right (Fig. 7). To activate trigger lock move
lever to the center off position.
Gear Shifting
Your tool is equipped with two separate gear
ranges, low gear and high gear. Low gear pro-
vides high-torque and slower drilling speeds
for heavy duty work or for driving screws.
High gear provides faster speeds for drilling
lighter work. To change speeds slide switch
(4), to the high or low position (Fig. 8).
ATTENTION: If your tool appears to be run-
ning, but the chuck will not turn, check to
make sure the gear shifting switch is pushed
fully into desired setting.
2610067354 GSR18V-400 02-22.indd 12
Operating Instructions
page heading
Fig. 6
(10)
turning
the
Fig. 8
-12-
Fig. 7
(10)
(4)
2/17/22 1:19 PM
Publicidad
